Starting And Stopping; Operation - Remington RM4020 Manual De Instrucciones

STARTING INSTRUCTIONS
To prevent the motor from starting accidentally, this unit has a
trigger lockout. The trigger cannot be squeezed unless the trigger
lockout is also engaged.
1. Install the battery. Refer to Installing the Battery.
2. Squeeze the trigger lockout into the front handle and hold it in
place (Fig. 6).
3. Continue to hold the trigger lockout. Squeeze and hold the
trigger to start the unit (Fig. 7).
4. Continue to squeeze the trigger lockout. Squeeze the trigger to
the degree needed for the operation.
STOPPING INSTRUCTIONS
1. Release the trigger and/or trigger lockout (Fig. 6 & 7).
2. Wait for all moving parts to come to a complete stop.
WARNING:
Do not expose power tools to rain or wet
conditions.
CHECKING THE BATTERY CHARGE LEVEL
1. Press the charge meter button (Fig. 8).
2. One or more of the charge meter lights should illuminate (Fig. 8).
The number and color of the lights will indicate the current
battery charge level:
• 3 Green Lights = 66 - 100% Charge
• 2 Green Lights = 33 - 66% Charge
• 1 Green Light = 1 - 33% Charge
• 1 Red Light = 0% Charge
3. If the red light illuminates, charge the battery before any further use.
NOTE: While in use, lithium-ion batteries provide power with
minimal power fade. When the battery is fully discharged, it will
immediately cut power to the unit and require charging.

STARTING AND STOPPING

OPERATION

Charge Meter Button
12
Front Handle
Trigger Lockout
Fig. 6
Trigger
Fig. 7
1% - 33%
33% - 66%
66% - 100%
Fig. 8
0%