Completing Electrical Connections, Ill. 9 - Audiovox NPC5000 Instrucciones De Manejo

Completing electrical connections, ill. 9

Lay all cables carefully. Refer to the connecting diagram on the fold-out page at the
end of this booklet and to the table below.
Power supply cable 2 (ISO connector A):
Pin no. Cable color
A1 black/white
A2 white/yellow
A3 white/brown
A4 red
A5 white/blue
A6 grey
A7 violet
A8 brown
G = connection required
❍ = connection optional
A A A A
Only connect electrical signals to appropriate terminals in the
vehicle.
A A A A
In the case of a direct connection to the battery secure the
positive connection (red lead) with a 10 A fuse close to the battery
(max. 4 - 6 inches).
1. Connect the free cable ends A4, A7 and A8 of the power supply cable 2 to
suitable terminals in the vehicle according to the connecting diagram and the
table.
2. Do not cut off unused cables! Wind them together and tie them back! They may
be used later to install additional features.
Speedometer signal (ISO connector A):
Connect the black/white cable A1 from cable harness to the tapping position of the
speedometer signal.
Note: Many cars are supplied with the speedometer signal on one of the car radio
connectors. Ask your car dealer for more information.
A A A A
Never tap the speedometer signal from the ABS control!
Connection
speedometer signal input
back-up lights (reversing signal)
mute signal output (open collector)
+12V permanent power supply, (via cable fuse
10 A if necessary)
not used
switch input low beam (do not connect to dash-
board illumination!)
+12V switched, (must not be interrupted during
engine start)
negative battery pole
Mounting instructions
G
G
❍
G
G
G
G
49