Olimpia splendid MIA 7,5 Instrucciones Para La Instalación, Uso Y Mantenimiento página 20

GB
Once the preceding points have been observed, it only means that the state of the stove
has been veri ed. It is necessary to thoroughly clean the smoke discharge tube or ue
and check the condition of the basket. If necessary, order a new one from our Authorized
Assistance Centre. If necessary, lubricate the hinges of the door and the handle. Also
check the ceramic bre cord near the glass, on the internal wall of the door; if it is worn
or too dry, order a new one from the Authorized Assistance Centre.
7.0 Annual maintenance performed by qualified
personnel
the work area to avoid
The following operations are to be programmed annually and are necessary to insure
that the product remains ef cient and guarantee safe operation.
ruct the slits placed on
• Careful cleaning of the combustion chamber;
• Cleaning and inspection of the smoke clearing ducts;
• Checking the seal of the gaskets;
works of art.
• Cleaning the mechanisms and moving parts (motors and fans);
• Checking the electrical parts and the electronic components.
t.
n have negative effects
7.1 Operations to perform every season before the rst lighting
• A general cleaning inside and outside;
in the room.
• A careful cleaning of the exchange tubes;
• A careful cleaning and disincrustation of the crucible and the relative cavity;
ent possibilities of elec-
• Clean the motors, checking the play and fastenings of the mechanisms;
• Clean the smoke channel (substitute the tube gaskets) and smoke extractor fan ca-
vity;
lower screen will read
• Clean silicone tube connected to the pressure switch;
g and ordinary mainte-
• Clean, inspect and disincrust the lighting resistor cavity, replacing it if necessary;
• Clean/check the synoptic panel;
• Visually inspect the electrical cables, the connections and the electrical power cable;
long periods of time.
• Clean the pellet container and verify the play with the screw feeder gear motor;
• Replace the door seals;
• Functional assessment, loading the screw feeder, lighting, 10 minutes of operation
and shut down.
environments that are ad-
on.
connect devices different
r electrical system usage
ch collects solid material
ance to the ue so that it
WARNING!
In case of re inside the chimney, immediately contact the re ghters.
Model:
Heating input (min-max):
Nominal heat output:
Reduced heat output:
CO emissions at 13% O2 (nominal heat):
CO emissions at 13% O2 (reduced heat):
Ef ciency at nominal heat output:
Ef ciency at reduced heat output:
Flue gas temperature at nominal heat output:
Flue gas temperature at reduced heat output:
Draught (min-max):
Voltage:
Frequency:
Electrical comsumption (ignition):
Electrical comsumption (working):
Weight:
Exhaust gas ow (reduced power)
Exhaust gas ow (at rated power)
The indicative heatable surface is 180 m
18
19
GB
3,38 kW -7,29 kW
6,66 kW
3,11 kW
0,016 %
0,032 %
91,26%
91,86%
142,5 °C
87,2 °C
10-12 Pa
230 V
50 Hz
280 W
100 W
61 kg
5.0 g/S
4,0 g/S
3