Installation Diagram Of Indoor And Outdoor Units; Optional Installation Parts - Toshiba RAS-B10N3KV2-E1 Manual De Instalación

INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS

INSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
8
(
Flat head
Battery cover
wood screw
&
Flat head
wood screw
3
Batteries
2
Wireless remote control
The provided Remote Controller is a wireless
type, which also can be used as a wire.
Please see "How to Connect The Remote
Controller for Wired Operation", in case of
wired control is required.
When installing the outdoor unit, leave open
in at least two of direction (A), (B), (C) and (D)
shown in the fi gure on the right.
Remark :
• Detail of accessory and installation parts can
see in the accessory sheet.
• Some pictures might be different from the
actual parts.

Optional Installation Parts

Part
Parts name
code
Refrigerant piping
Liquid side : Ø6.35 mm
Gas side : Ø9.52 mm
A
(RAS-B10, 13N3KV2-E1)
: Ø12.70 mm
(RAS-B16N3KV2-E1)
Pipe insulating material
B
(polyethylene foam, 6 mm thick)
C
Putty, PVC tapes
5
Filter
8
Flat head
4
Remote control holder
wood screw
Vinyl tape
Apply after carrying
out a drainage test.
(C)
(B)
Q'ty
One
each
1
One
each
Hook
1
Installation
plate
Shield pipe
Saddle
(D)
Extension drain hose
(Not available, provided
by installer)
(A)
Fixing bolt arrangement of outdoor unit
• Secure the outdoor unit with fi xing bolts and nuts if the unit is likely to be
exposed to a strong wind.
• Use Ø8 mm or Ø10 mm anchor bolts and nuts.
• If it is necessary to drain the defrost water, attach drain nipple 9 and cap
water proof ! to the bottom plate of the outdoor unit before installing it.
125 mm
108 mm
28 mm
Air inlet
Air outlet
600 mm
w
When using a multi-system outdoor unit is used, refer to the installation
manual provided with the model concerned.
3
For the rear left and left piping
Wall
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
Do not allow the drain hose to get slack.
Cut the piping
hole sloped
slightly.
Make sure to run the drain hose sloped
downward.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Left
Bottom Rear
right left
Bottom left
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam
* Drain nipple and cap
water proof are packed
in outdoor unit.
90 mm
Drain outlet
EN
ES
FR
IT
DE
PT
PL
RU
CR
HU
TR
GR
FI
DK
BG
LV
SI