Transport And Storage - Far Tools CH 1T Traduccion Del Manual De Instrucciones Originale

8. Avoid excessive rocking,
9. Do not subject the equipment to shocks and falls,
10. Do not defeat the safety Iinguets hooks,
11. The welding work on and near the hook is PROHIBITED. The chain is not to be used as ground Welding.
12. Do not use the hoist to transport people,
13. Do not use string as the Judgment of limit,
14. Never attach the load through the nose hook.
INSTALLATION I MAINTENANCE / INTERVENTION:
- Ensure the rigidity of the attachment structure of the apparatus,
- Replace any suspicious or used item,
- Véritier operation and adjustment of safety devices before each use
- Keep clean and properly oiled chain
- Check the tightness of joints elements
- Check that the chain is not vriliée and it has no defects (deformation, wear, cracks or corrosion mark)
- Ensure the implementation of the judgment chain positioned at the end of chain strand. It must be unloaded.
- Check that the suspension hooks and load show no deformation, damage, wear and corrosion marks. Check
the effectiveness of safety latches on hooks.
- After use, clean and lubricate the chain.
- Maintenance and repairs must be performed by qualified personnel.
- After repair, make no load and full load testing before use
Product maintenance must be performed by qualified personnel
Caution: a × e gear, the center of friction and pulleys are under spring pressure and they can go out of the unit during disassembly. To change the brake
discs, remove the cover hand wheel and hand wheel to indicate the brake assembly. By collecting
brake mechanism, make sure that the ratchet wheel, the center of friction and the boss and the brake discs are free of fat and latches are fully engaged
in the wheel
Tighten the nut securing the hand wheel and loosen up slightly to allow a cotter pin to be inserted. The string must be installed with the sides of the
welded links upwards, away from the groove of the load gear.
Replacing the load chain (only performed by authorized personnel) _ Listed cie welded chain load face
upwardly away from the groove of the sprocket wheel load.
After repair, test your product to 1.25x the maximum weight of your product (in this case: 1T 250kg).

TRANSPORT AND STORAGE:

Handle the camera by its structure or by the device engraved for this purpose or in its original packaging. Store the product away atmospheres
aggressive (dust, moisture, heat, .....)
it should be cleaned and protected against corrosion (lubrication).
182008-2-Manual-C.indd 14 182008-2-Manual-C.indd 14
SECURITE - SECURITY - SECURIDAD
SICUREZZA - SEGURANÇA
© FAR GROUP EUROPE
EN
06/07/2020 12:09 06/07/2020 12:09