Battery; Charging Procedure; Battery Handling; Environmental Protection - Gesipa AccuBird Instrucciones De Manejo Con Lista De Repuertos

Ocultar thumbs Ver también para AccuBird:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
Do not operate this battery charger at altitudes
exceeding 2.000 meter above sea level.
This battery charger should not be operated
neither by physically disabled or mentally
affected people, nor by untrained or unskilled
people.

2.2.2. Battery

Caution:
Following safety rules must be followed
for adequate protection against electrical shock,
injuries or fire hazards:
Never try to charge a damaged battery.
Do not insert a dirty or wet battery into the
charger.
Never throw batteries into the waste, into fire
or into water.
Do not charge a battery when the environment
temperature is below 0°C.

2.3. Charging procedure

Charge only GESIPA batteries when the environ-
ment temperature is between 0°C and 40°C.
Take the charger out of its package and connect
to mains. Check the input voltage on the type
label before connecting.
Insert the battery in the right way (pole+ to
pole+) into the charger bay. Insertion should
take place without noticeable effort.
The charging operation starts automatically
when the battery is inserted into the charging
bay.
Function lights:
Steady green: Battery is charged,
preserv.charge in process
Blinking green: Charging
Steady red:
Charging temperature out of range
(battery too hot or too cold)
Blinking red:
Battery is defective
Typical charging cycles:
Type
Part Number
1,3 Ah
725 1045
2,6 Ah
725 1049
*charging cycles may vary according to the rest capacity and the
battery temperature.
12
Charging cycle*
approx. 50 min
approx. 100 min

2.4. Battery handling

Use only cold batteries to obtain optimum
charging.
The GESIPA batteries can be charged approx.
1.000 times and reaches its maximum capacity
only after several charging cycles.
Do not insert the battery into the charger after
each use, but wait until the battery is fully dis -
charged (tool cannot set the rivet).
Recharge the battery after a long period of
inactivity.
Battery autonomy becoming shorter despite of
proper recharging means that the battery must
be replaced.
Keep the battery in dry and warm rooms.
The optimum operating temperature range is
10°C to 50°C.

2.5. Environmental protection

If batteries have to be replaced,
the following instructions should be
followed:
Bring back discarded batteries to your GESIPA
agent or to GESIPA for recycling.
Never throw away discarded batteries into
waste, fire or water.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

100217

Tabla de contenido