Troubleshooting - Poulan Pro SM446E Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
TABLE
,_
WARNING:
Aiways stop unit and disconnect spark plug before performing all of the
recommended remedies below except remedies that require operation of the unit,
TROUBLE
Engine will not
start.
CAUSE
REMEDY
1. Move ON/OFF switch to ON.
1. ON/OFF
switch
in
OFF position.
2. Engine flooded.
3. Fuel tank empty.
4. Spark plug not firing.
5. Fuel not reaching
carburetor.
6. Carburetor
requires
adjustment.
Engine will
1. Idle speed set too high
not idle
or too low.
properly.
2. Crankshaft
seals worn.
3. Compression
low.
1. Air filter dirty.
2. Spark plug fouled.
Engine will not
accelerate,
lacks power.
or dies under
a load.
Engine
smokes
excessively.
3. Carburetor
requires
adjustment.
4. Carbon
build-up
on
muffler outlet screen.
5. Compression
low.
1. Choke
partially on.
2. Fuel mixture
incorrect.
2. See "Starting
a Flooded
Engine" in
Operation
Section.
3. Fill tank with correct fuel mixture.
4. Instatl new spark plug.
5. Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
6. Contact
an authorized
service dealer.
1. See "Carburetor
Adjustment"
in
Service and Adjustments
Section.
2. Contact
an authorized
service dealer.
3. Contact
an authorized
service dealer.
1. Clean or replace
air filter.
2. Ctean or reptace plug
and regap.
3. Contact
an authorized
service dealer.
4. Contact
an authorized
service dealer.
5. Contact
an authorized
service dealer.
1. Adjust
choke.
2. Empty fuel tank and refill with
correct
fuel mixture.
3. Clean or replace
air filter.
4. Contact
an authorized
service dealer.
3. Air filter dirty.
4. Carburetor
requires
adjustment.
Engine
runs
1. Fuel mixture
incorrect.
1. See "Fueling
Engine" in Operation
hot.
section.
2. Spark
plug incorrect.
2. Replace with correct
spark plug.
3. Carburetor
requires
3. Contact
an authorized
service dealer.
adjustment.
4. Carbon
build-up
on
4. Contact
an authorized
service dealer.
muffler outlet screen.
Chain moves at
1. Idle speed requires
1. See "Carburetor
Adjustment"
in
idle speed,
adjustment.
Service and Adjustments
Section.
2. Clutch requires
repair.
2. Contact
an authorized
service
dealer.
17

Publicidad

Tabla de contenido
loading

Tabla de contenido