Briggs & Stratton Elite Series Instrucciones De Uso página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HOW TO USE PRESSURE
WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-800-743-4115.
Pressure Washer Location
Pressure Washer Clearance
WARNING
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide will cause nausea,
fainting or death.
• Operate pressure washer ONLY outdoors.
• Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
• DO NOT operate pressure washer inside any building or
enclosure.
The pressure washer must be at least 5 ft. (152 cm) from
structures having combustible walls and/or other
combustible materials. Leave at least 3 ft. (92 cm) all around
pressure washer including overhead, for adequate cooling,
maintenance and servicing.
Place pressure washer in a well ventilated area, which will
allow for removal of deadly exhaust gas. DO NOT place
pressure washer where exhaust gas could accumulate and
enter inside or be drawn into a potentially occupied
building. Ensure exhaust gas is kept away from any
windows, doors, ventilation intakes or other openings that
can allow exhaust gas to collect in a confined area
(Figure 9). Prevailing winds and air currents should be taken
into consideration when positioning pressure washer.
Figure 9 — Pressure Washer Clearance
Typical Pressure
Washer Shown
Exhaust Port
Operation
To Start Your Pressure Washer
To start your pressure washer for the first time, follow
these instructions step-by-step.This starting information
also applies if you have let the pressure washer sit idle for
at least a day.
1.
Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.8 gallons per minute and no less than 20 PSI at
pressure washer end of garden hose.
2.
Check that high pressure hose is tightly connected to
spray gun and pump. See "Preparing Pressure Washer
for Use" for illustrations.
3.
Make sure unit is in a level position.
4.
Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
CAUTION
DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5.
Attach nozzle extension to spray gun (Figure 10).
Tighten by hand.
Figure 10 — Connect Nozzle Extension to Spray Gun
6.
Choose ProjectPro™ nozzle you want to use, pull
back on collar of nozzle extension, insert nozzle and
release collar.Tug on nozzle to make sure it is securely
in place (Figure 11). See "How to Use ProjectPro™
Nozzle System".
Figure 11 - Attaching ProjectPro™ Nozzle to Nozzle Extension
7.
Engage trigger lock on spray gun trigger (Figure 12).
Figure 12 — Spray Gun with Safety Latch Engaged
9
Section
4
Safety Latch

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

0202512900 psi

Tabla de contenido