Briggs & Stratton Elite Series Instrucciones De Uso página 11

How to Use ProjectPro™ Nozzle
System
The quick–connect on the nozzle extension allows you to
switch between four different ProjectPro™ system nozzles.
The ProjectPro™ nozzles vary the pressure and spray
pattern as shown (Figure 14).
Figure 14 — Nozzle Spray Patterns
Low Pressure
High Pressure
Delicate
40° Yellow 15° Orange
2550 PSI 2800 PSI
2.8 GPM 2.5 GPM
Follow these instructions to change ProjectPro™
nozzles:
1. Engage trigger lock on spray gun.
CAUTION
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
• NEVER exchange ProjectPro™ nozzles without locking the
trigger lock on the trigger.
• DO NOT twist ProjectPro™ nozzles while spraying.
Black
Use to apply
detergent
General Max
0° Red
2900 PSI
2.3 GPM
Section 4: Operation
2. Pull back collar on quick–connect and pull current
ProjectPro™ nozzles off. Store ProjectPro™ nozzles in
holder provided on the accessory tray.
3. Select desired ProjectPro™ nozzle:
• For delicate rinse (lower pressure and higher
flow), for gentle cleaning of cars/trucks, boats, RV's,
patio furniture, lawn equipment, etc., select yellow
Delicate ProjectPro™ nozzle (Figure 15).
Figure 15 — Delicate Nozzle
• For general rinsing (medium pressure and medium
flow), ideal for most all purpose cleaning such as
home siding, brick patios, wood decks, driveways
and sidewalks, garage floors, etc., select orange
General ProjectPro™ nozzle (Figure 16).
Figure 16 — General Nozzle
11