Briggs & Stratton ELITE Serie Instrucciones De Uso página 12

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
Section 4: Operation
• For maximum rinsing (higher pressure and lower
flow), for stubborn or hard to reach surface such
as second story surfaces, paint removal, oil stains,
rust removal or other stubborn substances (tar,
gum, grease, wax, etc.), select red Max
ProjectPro™ nozzle (Figure 17).
Figure 17 — Max Nozzle
• To apply detergent, applies project specific cleaners
to help break down stubborn dirt and grime on a
variety of surfaces, select black ProjectPro™
cleaning detergent nozzle (Figure 18).
Figure 18 — Cleaning Detergent Nozzle
4. Pull back on collar, insert new ProjectPro™ nozzle and
release collar.Tug on ProjectPro™ nozzle to make sure
it is securely in place.
5. For most effective cleaning, keep ProjectPro™ nozzle
from 8 to 24 inches away from cleaning surface. If you
get ProjectPro™ nozzle too close, you may damage
cleaning surface.
6. DO NOT get closer than 6 inches when cleaning tires.
www.mymowerparts.com
Cleaning and Applying Detergent
IMPORTANT: Use detergents designed specifically
for pressure washers. Household detergents could
damage the pump.
CAUTION
You must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
To apply detergent follow these steps:
1. Review ProjectPro™ nozzle use.
2. Prepare chemical solution as required by manufacturer.
3. Pour chemical solution into chemical reservoir labeled
A or B.
NOTE: Each chemical reservoir holds two quarts.
4. Fill other chemical reservoir with a different prepared
solution, as desired.
5. Make sure black ProjectPro™ cleaning detergent
nozzle is installed.
NOTE: Detergent cannot be applied with the high
pressure nozzles (Yellow, Orange or Red).
6. Make sure garden hose is connected to water inlet and
water supply is turned on. Check that high pressure
hose is connected to spray gun and pump; start engine.
7. Rotate chemical shut-off valve on desired chemical
reservoir to "On" position (Figure 19).
Figure 19 — Chemical Shut-Off Valves
"On" Position
CAUTION
DO NOT turn on both chemical shut-off valves at the
same time.
• Only one chemical solution should be used at a time to avoid
possible bodily injury and/or property damage.
12
"Off" Position