Briggs & Stratton ELITE Serie Instrucciones De Uso página 13

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
8. Apply detergent to a dry surface, starting at lower
portion of area to be washed and work upward, using
long, even, overlapping strokes.
9. Allow detergent to soak in between 3–5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow detergent
to dry on (prevents streaking).
Pressure Washer Rinsing
After detergent is applied, scour the surface and
rinse it clean as follows:
1. Apply trigger lock to spray gun.
2. Make sure both chemical shut-off valves are in "Off"
position.
3. Remove black ProjectPro™ cleaning detergent nozzle
from nozzle extension.
4. Select and install desired ProjectPro™ nozzle, as
described in "How to Use ProjectPro™ Nozzle
System".
www.mymowerparts.com
Section 4: Operation
5. Keep spray gun a safe distance from spray surface.
WARNING
High pressure spray could cause you to fall if
you are too close to the cleaning surface.
• Keep spray nozzle between 8 to 24 inches away from cleaning
surface.
• Operate this unit on a stable surface.
• Be extremely careful if you must use the pressure washer from
a ladder, scaffolding or any other relatively unstable location.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
6. Apply a high pressure spray to a small area and then
check the surface for damage. If no damage, proceed to
step 7.
7. Start at top of area to be rinsed, working down with
same overlapping strokes used for cleaning.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°F.The system engages to cool the pump by
discharging the warm water onto the ground.
13