Tabla de contenido
Publicidad
Problems
* The processed product gets
stuck inside the machine.
*
Lack of expeller disc
*
*
Motor belt is skidding
*
The safety device of the
pusher lever is not adjusted
o r w i t h s o m e b a d
connection
*
The disc stops during the
operation
.
* The safety device of the disc
chamber lid presents some bad
connection.
Bad connection on the
*
ON/OFF switch
*
Bad connection on the plug
or electric cord
*
Lack of electricity
The machine does not turn
*
on
.
19
Causes
Solutions
*
Put the expeller disc, as
indicated on items 3.2 and 3.3
.
of this guide.
.
*
Check if the plug is
Lack of electricity
.
connected to the power
point
.
*
Adjust the tension of the
belt, as indicated on item 5.2
.
of this guide
.
* Calibrate the safety device
of the pusher lever and check
electrical connections, as
described on item 5.2 of this
.
guide.
*
Call technical assistance
*
Check ON/OFF switch
connections
.
.
*
Check if the cord is broken
and check the plug pins
.
.
*
Check if there is electric
power supply
.
3.4.2 Con mucho cuidado con las cuchillas, agarre el disco
girándolo en el sentido ante horario y, tirándolo hacia arriba, sáquelo de la cámara
de los discos.
Figura - 10
3.4.3 Agarre en la parte izquierda inferior de la reja y tirela hacia
arriba, siempre cuidando las cuchillas cortantes.
Figura - 11
.
.
3.4.4 Remueva la tapa del compartimiento de los discos , para
eso, agarre la tapa empujándola hacia atrás desalojándola totalmente de los
encajes del compartimiento de los discos .
Disco Corte Cubo
36
Publicidad
Tabla de contenido
