Echo CCS-58V Manual Del Operador página 28

MAINTENANCE
CORRECT TOP PLATE
FILING ANGLE
30°
CORRECT SIDE
PLATE FILING
ANGLE
80°
DEPTH GAUGE JOINTER
Lubricate the socket at the end of the guide bar
using a grease syringe in the lubricating hole.
Turn the guide bar and check that the lubrication
holes and chain groove are free from impurities.
28
INCORRECT TOP PLATE FILING
ANGLE
LESS
MORE
THAN 30°
THAN 30°
Fig. 40
INCORRECT SIDE PLATE
FILING ANGLE
HOOK
BACKWARD
SLOPE
Fig. 41
FLAT FILE
Fig. 42
RESTORE ORIGINAL
SHAPE BY ROUNDING
THE FRONT
Fig. 43
A bar with any of the following faults should be
replaced immediately:
Wear inside the bar rails that permits the chain
to lay over sideways
Bent guide bar
Cracked or broken rails
Spread rails
Transporting and Storing
See Figure 45.
Do not store or transport the chain saw when
it is running. The chain saw should always be
idle before storing or transporting.
Remove the battery pack from the chain saw.
Always place the guide bar scabbard on the
bar and chain before storing or transporting the
chain saw. Use caution to avoid the sharp teeth
of the chain.
Clean the chain saw thoroughly before storing.
Store the chain saw indoors, in a dry place that
is locked and/or inaccessible to children.
Keep away from corrosive agents such as gar-
den chemicals and de-icing salts.
English
LUBRICATING HOLE
Fig. 44
Fig. 45