BLACK&DECKER KD561 Manual De Instrucciones página 23

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
FITTING THE DRILL BIT (KEYED CHUCKS)
Proceed as follows:
Disconnect the plug from the electricity supply.
the end of the chuck key in one of the three holes in the
body of the chuck and the head of the chuck key
engaged with the barrel of the chuck. Turn the chuck
key clockwise to tighten the jaws and securely grip the
drill bit. Remove the chuck key.
REMOVING THE CHUCK (KEYLESS CHUCKS)
Proceed as follows:
the chuck and tighten the jaws. Give the allen key a
short powerful blow in an anti-clockwise direction with
a hammer to loosen the chuck on the spindle. Remove
the allen key. Use the screwdriver to turn the set-
screw clockwise until it totally disengages from the
spindle. Remove the chuck from the spindle by rotating
it anti-clockwise. To fasten the chuck, put it on the
thread and turn it clockwise until it stops. Put in the
screw and turn it anti-clockwise until absolutely firm.
REMOVING THE CHUCK (KEYED CHUCKS)
Proceed as follows:
Rotate the barrel
of the chuck until
the jaws are
sufficiently open.
Insert the drill bit
in the jaws of the
chuck. Insert the
chuck key with
To remove the chuck,
open the jaws, hold
it firmly in one hand
and with a screwdriver
held in the other hand,
turn the set-screw in
the chuck clockwise
approximately one
turn, to loosen it.
Place an allen key in
To remove the chuck,
open the jaws of the
chuck with the chuck
key. Hold the chuck
firmly in one hand, and
with a screwdriver
turn the screw set in
the chuck clockwise
with the other hand
until it comes out.
Use only the correct chuck key. Place the chuck key
into the chuck, and hold the drill firmly in one hand with
the chuck pointing away from you. Rotate the chuck so
that the chuck key is just above the horizontal position
on the right hand side of the machine. Give the
crossbar end of the key a sharp downward blow with a
mallet or light hammer. The chuck should now be
sufficiently loose to be unscrewed by hand.
FITTING THE SIDE HANDLE
Proceed as follows:
position. Tighten the handle by turning clockwise.
PREPARING YOUR DRILL FOR OPERATION
Proceed as follows:
rule, for large size drill bits use low speeds and for
smaller drill bits use high speeds.
ENGLISH
To assemble the
side handle, fit the
bolt in the clamp
and the nut in the
handle. Loosely
assemble the
handle and clamp.
Position the side
handle on the
body of your drill.
Rotate the handle
around the body
of your drill until it
is in the desired
Fit the correct
accessory for the job.
Set the speed of your
drill. On two-speed
drills, set the two-
speed switch to '1'
(low-speed) or '2'
(high-speed), or set
the variable speed
control to the desired
speed. As a general
Set the forward/
reverse switch to the
desired direction of
rotation. Never change
the setting of the
hammer switch, the
speed switch or the
forward/reverse when
your drill is operating.
23

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Kd661Kd562Kd662Kd564Kd664

Tabla de contenido