24-Port 1U Rack-Mount Power over Ethernet
To maximize performance with Power ovwer Ethernet (PoE) applications, these patch panels are specially designed to prevent spark-gap erosion
that degrades the plug and jack contacts over time and can impact data and/or power transmission capabilities.
Installation
1
Strip the cable jacket approximately 1.25 in. (30 mm).
3
Use a 110 impact tool for termination.
Note: Set the tool to the "Low Impact" setting.
PROTECT YOUR INVESTMENT!
Register your product for quicker service and ultimate peace of mind.
You could also win an ISOBAR6ULTRA surge protector—a $100 value!
www.tripplite.com/warranty
17-11-012-933783.indb 1
Quick Start Guide
(PoE)* 110 Patch Panels
Models: N052-P24 (Cat5e), N252-P24 (Cat6)
Español 3 • Français 5 • Русский 7
22-24 AWG
Figure 1: T568A/B Wiring Scheme
Avoid gaps
2
Seat each wire according to the wiring scheme shown in Figure 1.
Ensure the untwisted length is as short as possible. Avoid overlapping
one pair over the others.
Note: 110 punchdown orientation may vary by model.
Wrap strap
around cables.
4
In order to maintain stable performance, ensure the cable bundles
are secured with the attached straps.
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright © 2017 Tripp Lite. All rights reserved.
1
11/28/2017 1:55:05 PM