Russell Hobbs 20150-56 Manual De Instrucciones página 4

BEFORE USING FOR THE FIRST TIME
Fill the reservoir to the max mark, and run the appliance without coffee.
FILLING
1. Remove the carafe from the hotplate.
2. Use the grip to open the lid, and expose the reservoir.
3. Fill with at least 2 cups of water, but not above the max mark.
4. Open up a #4 paper filter, and put it into the filter holder.
5. Put 1 scoop of filter-ground coffee into the filter for each cup.
6. Close the lid.
7. Replace the carafe on the hotplate.
SWITCH ON
1. Put the plug into the power socket.
2. 12:00 will flash on the display.
COFFEE NOW
1. Ignore the clock.
2. Press the W button. The button will light up.
3. Shortly afterwards, coffee will start to drip into the carafe.
4. If you want to stop the coffee maker while it's brewing, press the W button.
5. When it's done, the hotplate will keep the carafe warm.
AUTO SHUT-OFF/SLEEP MODE
About 40 minutes after brewing finishes, the appliance will shut down.
After 15 seconds of inactivity, the appliance will go to sleep.
To wake the appliance, press the min button.
COFFEE LATER
1. The clock will retain its settings until the coffee maker is unplugged.
2. It's a 24 hour clock.
3. Set the clock to the correct time.
4. Use the h and min buttons to set the correct hour and minute.
5. Set the timer to the time you want to start brewing.
Press the T button.
6.
Use the h and min buttons to set the correct hour and minute.
7.
8. If you don't press either the h or min buttons within 5 seconds, the coffee maker will revert to
"normal", and the time will show. You'll have to press the T button, and start again.
ACTIVATION
1. Press the AUTO button. AUTO will show on the display.
2. At the time you set, the W button will light up, and the coffee maker will start up.
3. To cancel the timer before brewing has started, press the button again.
REMEMBER
If you forget what time you've set it to, press and hold the T button, then release it.
4