FIXED PANEL AND SUPPORT BAR INSTALLATION
1. Place the 2 support bar's anchors (D) back on their wall mark, then mark their center on the wall.
2-4. Drill a hole on the center marks with a ø8mm (5/16in) drill bit and insert the wall anchors (AA) using a rubber
mallet. Fix the center fitting on the support bar's anchor (D) using the screws (GG).
5-6. Insert the fixed panel (C) into the metal track (B). Then fix the support bar to fixed panel (C) by the fixed panel's
bracket (G).
7. Secure the support bar (F) on their anchors using the provided hex screws. Position the roller stopper (E) in order
to block the door panel (J) from hitting the wall when opening it. Use the Allen key to strongly secure the stopper when
the final position is found.
1
D
3
AA
5
B
C
C
6
F
G
12
2
Φ8mm
5/16in
4
GG
D
7
D
E