Glacier bay 67416-3701 Guía De Uso Y Mantenimiento página 6

Installation (continued)
3
Installing the spout assembly
□
Install the spout assembly (A) onto the
connector (D). Be sure the spout assembly
is resting rmly on the deck.
□
Push down on spout and tighten set screw (B)
with the Hex wrench (AA). Insert the index (C).
A
C
AA
B
D
6
4
Installing the hot and cold
valves and handle assemblies
NOTE: After install handle assembly, if the handle seat is
not aligned with handle in a line as shown in the
above diagram (2), rotate the handle seat back (the
ratating angle can not exceed 90°) to make the
handle seat align with handle in a line.
□
From underneath the deck, insert the cold end
valve (L) with the rubber washer (M), metal
washer (N), and mounting nut (O) through the
hole on the right (cold) side.
□
From above, thread the ange (J) onto the valve.
□
Tighten the mounting nut (O) using a basin
wrench, so that the ange (J) sits ush against
the nished deck surface.
□
Thread the handle (I) onto the ange (J).
□
Repeat this procedure for the hot end valve (K)
on the left (hot) side.
K
2
I
J
1
M
L
N
O