GYS NOMAD POWER PRO 45 Manual De Instrucciones página 7

OR
STARTING THE VEHICLE
Emergency start function for petrol or diesel vehicles with a 12V battery.
To start a vehicle, please process as follows:
!
If the voltage of the vehicle battery is > 12.5V, the NOMAD POWER will not function properly.
1
2
3
4
5
60"
6
7
If the engine does not start after doing the above steps, it means that the vehicle's battery could be
drained excessively (excessively discharged to less than 2V). Or a reverse connection. Please review the
following steps:
NOMAD POWER PRO 45
1 - Connect car adaptor to the car cigarette lighter socket.
2 - Connect the other end to the NOMAD POWER PRO to start the charge.
Disconnect the charger when the green LED indicator is on.
Make sure the battery terminals on the vehicle to be boosted are well cleaned with no
grease or corrosion.
Connect the booster cable plug into the booster cable socket.
1- Connect the red clamp to the (+) of the battery.
2- Connect the black clamp to the (-) of the battery.
Double check the connection. If the booster cable clamps are cross-connected on the
vehicle's battery, please correct them immediately.
Reverse connection will cause damage and explosion.
Press the power button (1) for 5 seconds. All four LED indicators will be illuminated
successively.
Then, the LED indicator will show the level of battery status. It must be green light to
work with jump start function, if the capacity is low it may fail to jump start battery.
Press the Jump start button (2), all the LED indicators will be flash simultaneously
(If the LEDs are not flashing, see step 6b below)
The jump start function will be activated. Please start the engine within 60 seconds
(the jump start function will switch off automatically within 60 seconds).
When the engine has been started successfully, please press the power button (1) for
5 seconds to switch off the jump starter. Remove the booster cable clamps from the
vehicle's terminal.
.
EN
7