Metra 99-7355B Instrucciones De Instalación página 3

1. Secure the radio brackets to the pocket
using the (4) #8 x 3/8" Phillips screws
provided. (Figure A)
2. Secure the bracket/pocket assembly to
the radio trim panel using the (2) #6 x
3/8" Phillips screws provided. (Figure B)
3. Remove the metal "DIN" sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the bracket/pocket
assembly, then secure it using the screws
supplied with the radio. (Figure C)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
6. Secure the radio assembly to the dash
using the factory screws, then reassemble
the dash in reverse order of disassembly
to complete the installation.
KIT ASSEMBLY
(Figure A) (Figure B) (Figure C)
REV. 5/18/2018 INST99-7355B
3