Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts; Ordering Replacement Parts; Disposal And Recycling - Neptun NKSP-E 52 2in1 Manual De Instrucciones Original

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
•
Unplug the power plug prior to any mainte-
nance work.
•
For mobile applications, the equipment
should be cleaned with clear water after every
usage.
•
For stationary installation, it is recommended
that you check the floating switch for proper
operation every three months.
•
Use a water jet to remove any lint or fibrous
particles that may have become trapped in
the housing.
•
Remove sludge from the shaft bottom and
clean the shaft walls every 3 months.
•
Use clear water to remove deposits from the
floating switch.
8.1 Cleaning the intake cage and pump
housing (Fig. 4/5/6/7):
1. Screw out the three screws (Fig. 5/Item B)
counter-clockwise.
2. Turn the equipment up as far as the stop (Fig.
4). Note the position of the lug (Fig. 4/Item A)
and remove the intake cage (Fig.6/Item 3).
3. Clean the intake cage (Fig. 6/Item 3) and the
pump impeller housing (Fig.6/Item C) with
clean water.
4. Assemble in reverse order.
5. When assembled, the lug must be in the cor-
rect position (Fig. 7/Item A).
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
Anl_NKSP-E_52_2in1_SPK7.indb 16 Anl_NKSP-E_52_2in1_SPK7.indb 16
GB

8.3 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 16 -
28.01.2021 08:38:47 28.01.2021 08:38:47