Ega Master 56572 Manual De Instrucciones página 29

1. Place the square driver in the socket and the socket on the nut. Make certain the square
driver and socket are the correct size for the nut and that the driver fully engages the socket
and the socket fully engages the nut.
2. Position the reaction arm or surface against an adjacent nut, flange or solid system
component. Make certain that there is clearance for the hoses, swivels, inlets and end plug.
DO NOT allow the tool to react against the hoses, swivels, inlets or end plug.
3. After having turned the pump on and presetting the pressure for the correct torque, depress
the remote control button to advance the piston assembly.
4. When the wrench is started, the reaction surface of the wrench or reaction arm will move
against the contact point and the nut will begin to turn.
5. When the nut is no longer turning and the pump gauge reaches the preset pressure, release
the remote control button. The piston rod will retract when the button is released and under
normal conditions, an audible "click" will be heard as the tool resets itself.
6. Continue to cycle the tool until it "stalls" and the preset psi/torque has been attained.
7. Once the nut stops rotating, cycle the tool one last time to achieve total torque.
29