Installation; Wall Mount; Eave Mount - DESA Specialty Products JourneyMan HD-9260 Manual Del Usuario

Installation

CAUTION: BEFORE STARTING THE INSTALLATION, TURN THE POWER OFF AT THE
If you want to use the Manual Override feature you will need to install the fixture on a circuit controlled
by a switch. The lamps are packed in boxes, inside the lampheads. Open the lampheads by removing
the screws at the top. Use a clean cloth or the foam packing around the lamps to keep your fingers off
the lamps. Install the lamps in the right side of the sockets first, then the left. Close the lampheads and
continue the installation as shown below.

Wall Mount

❒
Loosen the thumbscrews holding the sensor
head and lampheads.
❒
Adjust the various parts so that the fixture
looks similar to this illustration.
❒
Finger tighten the thumbscrews at this time.
• Allow fixture to cool before touching. The bulb and the fixture
• Keep fixture at least 3" (76 mm) from combustible materials.
• Use only type T 250W (max.) tungsten halogen 120 VAC lamps.
598-1146-01
CIRCUIT BREAKER.
CAUTION: To Avoid Fire Or Burn Hazards:
operate at high temperatures.
Do not aim at objects closer than 3' (1 m).

Eave Mount

❒
Loosen the thumbscrews holding the sensor
head and lampheads.
❒
Adjust the various parts so that the fixture
looks similar to this illustration.
❒
Finger tighten the thumbscrews at this time.
-5-