Crossbar Mounting Bracket; Standard Wiring - DESA Specialty Products JourneyMan HD-9260 Manual Del Usuario

Mount Fixture with Crossbar
Mounting Bracket
❒
Turn power off at the fuse or circuit breaker.
❒
Remove the existing light fixture (if appli-
cable).
❒
Install the mounting bracket as shown using
two screws supplied in hardware pack that fit
your junction box:
Rectangular Junction Box - Use two #6-32
x 3/4" screws.
Circular or Octagonal Junction Box - Use
two #8-32 x 3/8" screws.
Watertight Junction Box - Use two #10-24
x 1/2" screws.
❒
The plastic hanger can be used to hold the fix-
ture while wiring. The small end of the plastic
hanger can be threaded through the hole in the
center of the cover plate. The small end then
goes into one of the slots on the mounting
bracket.
❒
Route the Light Control's wires through the
large gasket holes.

Standard Wiring

CAUTION: If you have not already turned the
power off at the breaker or fuse, do so now.
Connect the junction box wires to the fixture wires.
Twist together and secure with wire connectors.
CAUTION: If you are not controlling additional
fixtures from your JourneyMan
connect the RED wire.
Junction Box
Green ground
wire to
junction box
ground wire
RED, not
used in most
applications
-6-
®
fixture, DO NOT
Mounting
Bracket
White to
White
Black to
Black
Gasket
598-1146-01