Rebel RB-1011 Manual Del Usuario página 35

4. Keep handles and grips dry, clean and free from oil and grease.
5. Hold power tool by insulated gripping surfaces, when performing an operation
where the cutting accessory may contact hidden wiring or its own cord. Cutting
accessory contacting a "live" wire may make exposed metal parts of the power tool
"live" and could give the operator an electric shock.
6. Do not use the power tool if the switch does not turn it on and off. Any power tool
that cannot be controlled with the switch is dangerous and must be repaired.
7. Disconnect the plug from the power source and/or the battery pack from the power
tool before making any adjustments, changing accessories, or storing power tools.
Such preventive safety measures reduce the risk of starting the power tool accidentally.
8. This power tool may be used by children who are above 8 years old and by persons with
reduced physical, sensory or mental capabilities, or lack of experience and knowledge,
if they are supervised and guided by a person who is responsible for their safety in a
cautious manner for all the safety precautions being understood and followed.
9. Store idle power tools out of the reach of children and do not allow persons unfamiliar
with the power tool or these instructions to operate the power tool. Power tools are
dangerous in the hands of untrained users.
10. Maintain power tools. Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power tool's operation. If
damaged, have the power tool repaired before use. Many accidents are caused by
poorly maintained power tools.
11. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
12. Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from those intended could
result in a hazardous situation.
Service
1. Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
Battery tool use and care
1. Do not attempt to open the battery. If the battery is damaged in any way, stop using
it and do not attempt to recharge it. Short-circuit or electric shock or explosion hazard.
2. Protect the battery pack against any heat source (e.g. direct sunlight exposure, fire,
heater etc) to prevent any damage or explosion hazard.
3. Do not expose the battery pack to water, moisture and cold. Risk of electric shock.
4. In case of damage and improper use of the battery, vapors may be released. Ensure
proper ventilation and provide for fresh air to the work area. The vapors can irritate
the respiratory system.
5. Recharge only with the charger specified by the manufacturer. A charger that is
suitable for one type of battery pack may create a risk of fire when used with another
battery pack.
35 EN