Rebel RB-1011 Manual Del Usuario página 43

MAINTENANCE
Before cleaning and maintenance, always switch off the power tool and remove
the battery.
Clean the casing regularly with a soft cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt. Remove very persistent dirt using a soft cloth
moistened with soapsuds. Do not use any solvents such as gasoline, alcohol, ammonia, etc.
Chemicals such as these will damage the synthetic components.
Clean the power tool before storing. Store the power tool, user manual and accessories
in the original packaging. Store the product in a clean, dry place protected from moist and
keep it out of the reach of children. Do not store the power tool in temperatures below 0°C.
Do not place or store any object on the top of the power tool.
Power tools used on fiberglass material, wallboard, spackling compounds or plaster are
subject to accelerated wear and possible premature failure because the fiberglass chips
and grindings are highly abrasive to bearings, brushes, commutators etc. Consequently, it
is not recommended to use this power tool for extended work on these types of materials.
However, if you do work with any of these materials, it is extremely important to clean the
power tool using the compressed air.
Special condition for battery transport
The lithium-ion batteries contained in the power tool are subject to the dangerous goods
requirements. When preparing the tool to be shipped, it is mandatory to consult a specialist
in hazardous materials. Also observe any national/local regulations which is likely to be
more detailed. Tape terminals or mask them and pack the battery so that it does not move
in the package.
The product and the user manual are subject to change. Specifications can be changed
without further notice.
43 EN