Work Light - Rebel RB-1011 Manual Del Usuario

Switching the power tool on and off
• Pressing the ON/OFF switch will activate the power tool.
• Releasing the ON/OFF switch will stop the power tool.

Work light

There is a work light on the front handle. It turns on when the ON/OFF switch is pressed. It
turns off when the ON/OFF switch is released.
Warning: The work light is intended to illuminate the power tool's direct area of working
operation and is not suitable for other purposes. Do not look directly into the light. Risk
of eye damage!
DRILLING
• When drilling hard, smooth surfaces, use a center punch to mark the desired hole
location. This will prevent the drill bit from slipping off-center as the hole is started.
• If the bit jams in the workpiece or if the drill stalls, stop the power tool immediately.
Remove the drill bit from the workpiece and determine the reason for jamming.
WOOD AND METAL DRILLING
• For maximum performance, use high speed steel drill bits for wood or metal drilling.
• Select drilling mode. Begin drilling at a very low speed to prevent the drill bit from
slipping off the starting point.
Wood drilling
• Increase the speed as the drill bit bites into the workpiece.
• When drilling through holes, place a block of wood behind the workpiece to prevent
ragged or splintered edges on the back side of the hole.
Metal drilling
• Use a light oil on the drill bit to keep it from overheating. The oil will prolong the lifespan
of the drill bit and increase the drilling action.
• Maintain the speed and pressure which allows cutting without overheating the drill bit.
Applying too much pressure will:
• Overheat the drill bit,
• Wear the bearings,
41 EN