INITIAL OPERATION
When you use your appliance for the first time, pour fresh water
•
into the water tank (without coffee) and switch on the appliance.
Once all the water has passed through, switch the appliance off
•
and let it cool down. When it is cold enough repeat the process
with fresh water. Repeat this process 3 times.
PREPARATION OF COFFEE
Open the lid of the water tank.
•
Pour the desired amount of water into the water tank. Make sure
•
not to overfill by respecting the maximum level indicated on the
water tank.
Swing the filter holder, insert a paper filter or permanent filter
•
(depending on the model) and add the desired quantity of
ground coffee. Replace the filter holder, making sure it is placed
correctly.
Never forget to close the lid of the water tank before switching
•
on your coffee maker.
Switch on the coffee maker. The pilot light of the switch will be
•
illuminated, indicating that your appliance works. Thanks to the
keep warm function, your coffee is warmed up as long as the
appliance is switched on. Note that the appliance will be
switched on as long as you do not switch it off manually. We
advise you not to let the appliance switched on more than 2
hours and make sure that you never let an empty jug on the
appliance.
When you remove the jug from the appliance, a non-drip valve
•
will automatically operate to stop any drops of coffee dripping
onto the hotplate. Replacement of the carafe automatically
opens the non-drip valve and allows remaining coffee to filter
trough into the jug.
Wait until the brewing process is finished and the filter has run
•
empty before removing the jug.
DECALCIFICATION AND CLEANING
Decalcifying the coffee maker prolongs its life span. For
•
decalcification only use products especially made for
decalcification of coffee makers.
4
USK CM 20903/CM25693 - 080429