Initial Operation; Setting The Clock; Preparation Of Coffee - Kalorik TKG CM 1017 T Manual De Instrucciones

INITIAL OPERATION

When you use your appliance for the first time, pour fresh water into the water tank and switch
on the appliance (without coffee).
Once all the water has passed through, switch the appliance off and let it cool down. When it
is cold enough, repeat the process with fresh water. Repeat this process twice.

SETTING THE CLOCK

• Plug in your coffee maker. The time "12:00" will be displayed on the electronic digital clock.
• To set the current time, press the PROGRAMME button once. "12:00" flickers and the word
"CLOCK" appears in the top right corner of the display.
• Then press the HEURE button to set the hours, and the MIN button to change the minutes.
• By each impulse on one of those buttons, the hour or minutes will increase by 1 unit but if
you keep the pressure, the time will roll forward more quickly.

PREPARATION OF COFFEE

• Open the lid of the water tank.
• Using the glass carafe, pour the desired amount of water into the water tank. Make sure
not to overfill by respecting the maximum level indicated on the water tank.
• Place the filter holder into the coffee maker. Put a filter in the filter holder and add the
desired quantity of ground coffee in the filter. Put back the filter holder, making sure it is
placed correctly.
• Never forget to close the lid of the water tank and to place the glass carafe on the
warming plate before switching on your coffee maker.
• Press the on-off switch (MARCHE/AUTO/STOP) to switch on the coffee maker. The pilot light
will be illuminated in red, indicating that your appliance is working. A device allows you to
keep coffee warm for as long as the coffee maker is working and the jug is standing on
the appliance.
• When you remove the jug from the appliance, a non-drip valve will automatically operate
to stop any drops of coffee dripping onto the hotplate. Replacement of the carafe
automatically opens the non-drip valve and allows remaining coffee to filter through into
the jug.
• Wait until the brewing process is finished and the filter has run empty before removing the
jug.
• You can switch off your appliance anytime simply by pressing the on-off switch twice (the
pilot light will be off).
• Your coffee maker will switch off automatically 40 minutes after it has stopped brewing
coffee.
PROGRAMMING THE COFFEE MAKER
To programme your coffee maker to brew fresh coffee at a preset time, first follow steps 1 to 4
in the "PREPARATION OF COFFEE" section.
Make sure the coffee maker's clock is set to the right time.
Press the PROGRAMME button twice. The clock will now display 12:00 with the word "TIMER" in
the upper left corner. Use the HOUR and MIN buttons to set the desired brew time. Once the
setting is finished, press the on-off switch (MARCHE/AUTO/STOP) twice. The programming time
will disappear and will be replaced by the clock time. The pilot light will be illuminated in blue.
(You can cancel the automatic start function by pressing the on-off switch
(MARCHE/AUTO/STOP) once or you can start brewing immediately by pressing it twice.)
When your preset brew time is reached and the coffee maker starts its brew cycle, the blue
light will go out and the red pilot light will illuminate.
13
TKG CM 1017 T - 170824