Preparing Music Or Sounds; Changing The Music; Changing The Sounds; Restoring The Memory Card - LGB SOEG 33350 Manual Del Usuario

Preparing Music or Sounds

The electronic circuit built into the car can only play back files in the WAV format,
with 16 kHz sampling rate, 16 bit sampling in mono. However you can also have any
other music file converted on the memory card from other accessible formats as
described below.

Changing the Music

1 Remove the micro-SD memory card from the car.
2 Connect the memory card to a Windows® PC.
3 Open the folder „Converter" on the memory card.
4 Select the desired pieces of music and use the mouse to transfer them to the file
„DATEI_HIER_DRAUFLEGEN".
5 The transfer will start. The files are converted in the process and are stored on the
memory card. The music is stored on the memory card in the folder „Musik". You
can delete existing or newly entered pieces of music as desired.

Changing the Sounds

Sounds are stored on the memory card in the folder „Geräusche". Here you can
place any other sounds or delete existing ones.
A maximum of only 5 sounds can be stored.
The easiest thing to do is to proceed as described for music and then position the
sounds in the right folder. Please note that the new sounds must replace the previous
ones and must have their names.

Restoring the Memory Card

The reproduction of music or sounds assumes certain folders on the memory card.
If the card should be formatted or replaced, the necessary folder structure can be
generated again from a ZIP file. See under „Downloads" at www.maerklin.de for this.
7