Style selections RBETB6026-91 Manual De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
1. LOWER BACK PANEL
Determine the width of the lower back wall panel
(A) by measuring from the top of the tub deck
and up 36 in. from the top of the tub. Measure the
width of the opening from these points. Note: If
the wall is not square, you can use cardboard (not
included) to create a template of the wall and
transfer the data to the lower back panel (A).
The 1/4 in. extension on the lower back panel (A)
is at the top of the panel.
2. Check the measurements, and then place
masking tape (not included) over the area where
the saw (not included) will contact the finished
side of the lower back panel (A). Cut the lower
back panel (A), and make any final adjustments to
the cuts with a sanding block (not included).
3. If needed, place 1/16 in. thick shims (not included)
at the base of the lower back panel's (A) installation
site. Trial fit the lower back panel (A) on the shims and
use a sanding block if any fine adjustments are
needed. Remove lower back panel (A) from wall and
clean the back of the lower back panel (A), the wall
board and any other area that will be in contact with
the silicone (L) with denatured alcohol and a clean rag
(both not included).
1
Measure
Finish
Side
2
Masking
3
4
Top
Glue
Side
A
A
Tape
A
Lowes.com
36 in.