Style selections RBETB6026-91 Manual De Instrucciones página 5

ASSEMBLY INSTRUCTIONS
4. Cut eleven 4-in. strips of installation tape
(N) and place them on lower back panel (A) where
indicated in figure 4. Apply silicone adhesive (L) in
3/4 in. diameter dots every 6-7 in. apart over
the surface of the reinforcement strips on the back
of lower back panel (A). Place the lower back
panel (A) in place and press firmly.
5. UPPER BACK PANEL
Determine the width of the upper back wall panel
(B) by measuring from the top of the lower back
panel (A) and 24 in. up from the top of the
lower wall panel (A). Repeat steps 1 and 2 for
upper back panel (B), noting the 1/4 in. extension
on upper back panel (B) is at the bottom.
6. Trial fit the upper back panel (B) on top of the
lower back panel (A) and use a sanding block
(not included) if any fine adjustments are needed.
Remove upper back panel (B) from the wall and
clean the back of the upper back panel (B), the
wall board and any other area that will be in
contact with the silicone (K) with denatured
alcohol and a clean rag (both not included).
4
N
5
Measure
Finish
Bottom
Side
6
5
L
A
L
24 in.
A
B
Glue
Side
B
A
Lowes.com
N