Side Panel - Style selections RBETB6026-91 Manual De Instrucciones

ASSEMBLY INSTRUCTIONS
7. Cut eleven 4-in. strips of installation tape (N) and
place them on upper back panel (B) where indicated
in figure 7. Apply silicone adhesive (L) in 3/4 in.
diameter dots every 6-7 in. apart over the surface
of the reinforcement strips on the back of upper back
panel (B). Apply a bead of silicone adhesive (L) into
the area where the lower back panel (A) and upper
back panel (B) connect. Place the upper back panel
(B) into the lower back panel (A) and press firmly
together and against the substrate.

8. SIDE PANEL

Measure from the back wall at the top and the bottom
of the back panel assembly to the edge of the tub
deck. The front edge trim (E) extends the left side
panel (C) and right side panel (D) width by a minimum
of 1/2 in. to a maximum of 1-1/2 in., so the left side
panel (C) and right side panel (D) width needs to be
cut a minimum of 1/2 in. shorter than your desired
finished side wall dimension. Note: If the wall is not
square, you can use cardboard to create a template
of the wall and transfer the data to the left side panel
(C) and right side panel (D). Be certain to use left side
panel (C) on the left side of the installation site and
right side panel (D) on the right side to ensure proper
tile pattern layout.
9. If no plumbing holes exist on side panel, proceed to
step 10. Locate the locations of the plumbing holes
and transfer the data to either left side panel (C) or
right side panel (D). Cut the holes a minimum of 1/4
in. larger than the pipe diameters. Note: To avoid
possible breakage, all inside corners of cutouts
should have a minimum 1/4 in. radius. Use masking
tape (not included) to protect the area where the
cutting tool will contact the finished surface.
7
Glue
Side
Finish
Side
N
8
9
6
L
N
A
L
B
L
C
D
C
C
D
Lowes.com