Publicidad
Step 12
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (F) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB (24K) to the DOOR (F). Use a BLACK
å
1-1/8" MACHINE SCREW (21S).
Repeat this step for the other DOOR (F).
å
See the next step for DOOR adjustments.
å
Hinge
www.sauder.com/services
24K
Stop
Mounting
screw
21S
BLACK 1-1/8" MACHINE SCREW
(2 used in this step)
B
F
418662
Pro Tip: Lift with your
legs. And, you know,
your arms.
Page 17
Publicidad
