Publicidad
Idiomas disponibles
Idiomas disponibles
If your spray gun should require extra internal
cleaning, it may be necessary to disassemble it. If
so the following action should be taken:
• Remove the plug from the mains socket.
• Remove paint container, pick up pipe and filter.
• Take off the pump assembly.
• Release the nozzle (H), valve (J), piston (K) and
spring (L).
• Clean the cylinder (M) and all parts thoroughly
with solvent.
• Apply a few drops of light lubricating oil to the
piston, spring and cylinder.
• Reassemble the spray gun.
Lubrication
The device does not need any additional
lubrication.
Defects
If a defect appears due to a part wearing out,
please contact the service center on the warranty
card. At the end of these instructions there is
an exhaustive overview of the parts that can be
ordered.
ENVIRONMENT
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Damaged and/or disposed of electrical or
electronic devices must be dropped off
at recycling stations intended for that
purpose.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
8
WARRANTY
Read the warranty conditions on the separately
supplied warranty card.
The product and the user manual are subject
to change. Specifications can be changed
without further notice.
Publicidad
