Black and Decker Powerful Solutions SMS216 Manual Del Usuario página 10

ENGLISH
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons
regularly using power tools in employment, an estimation of
vibration exposure should consider, the actual conditions of
use and the way the tool is used, including taking account of
all parts of the operating cycle such as the times when the
tool is switched off and when it is running idle in addition to
the trigger time.
Labels on tools
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Wear safety glasses or goggles.
Wear ear protection.
Wear a dust mask.
This product is not to be used by children
under 16
Keep fingers and arms away from rotational saw
blades.
Wear gloves when handling saw blades.
Laser radiation.
Do not look into the laser beam.
Do not use optical tools to view the laser beam.
Electrical safety
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
10
Voltage drops
In-rush currents cause short-time voltage drops. Under
unfavourable power supply conditions, other equipment may
be affected.
If the system impedance of the power supply Zmax<0.34,
disturbances are unlikely to occur.
Using an extension cable
Always use an approved extension cable suitable for
the power input of this tool (see technical data). Before
use, inspect the extension cable for signs of damage,
wear and ageing. Replace the extension cable if
damaged or defective. When using a cable reel, always
unwind the cable completely. Use of an extension cable
not suitable for the power input of the tool or which is
damaged or defective may result in a risk of fire and
electric shock.
Features
1. Laser on/off switch
2. Main operating handle
3. Motor housing
4. Moveable lower guard
5. Bench mounting holes
6. Kerf plate
7. Mitre lock knob
8. Mitre detent lever
9. Mitre position pointer
10. Mitre scale
11. Table
12. Left-hand fence
13. Laser
14. Carriage locking knob
15. Rear carry handle
16. Carriage
17. Saw dust outlet
18. Metal upper guard
19. Removable brush cap
20. Bevel scale
21. Bevel scale pointer
22. Bevel lock handle
23. Right-hand fence
24. Saw blade
25. On/off switch
26. Saw arm release lever
Fig Q to S
41. Spindle lock
42. Left-hand high sliding fence
43. High sliding fence clamp
44. Work piece clamp