Assembly And Operation - Worx WX803. Serie Manual Original

vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if its use
is not adequately managed.
WARNING! To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating cycle
such as the times when the tool is switched off and when
it is running idle but not actually doing the job. This may
significantly reduce the exposure level over the total
working period.
Help to minimize your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Intended use:
The machine is intended for cutting, roughing and
12
brushing metal and stone materials without using water.
For cutting metal, a special protection guard for cutting
(accessory) must be used.

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery pack
Installing the battery pack
WARNING: When replacing the
battery pack, do not insert the
battery until the Grinding/Cutting Disc
comes to a complete stop!
ASSEMBLY
Assembling Auxiliary Handle
Assembling Grinding/Cutting Disc
Lithium-Ion Cordless Angle Grinder
Adjusting Wheel Guard
Note: Before any work on the machine
itself, remove the battery pack.
For work with grinding or cutting
discs, the protection guard must be
mounted. Use the correct type of disc
for your application. If the power tool
is intended to perform cutting off
operations, a guard specific for this
operation must be fitted.
The coded projection on the wheel guard
ensures that only a guard that fits the
machine type can be mounted.
Open the clamping lever. Place the
wheel guard with coded projection into
the coded groove on the spindle of the
machine head and rotate to the required
position (working position).
To fasten the wheel guard, close the
clamping lever.
The closed side of the wheel guard
must always point to the operator.
OPERATION
Using On/Off Switch
Hand Grip Areas
Rough Grinding
Warning! Never use a cutting disc
for roughing.
Cutting
WORKING HINTS FOR YOUR
ANGLE GRINDER
FIGURE
1. Always start at no load to achieve maximum speed
then start working.
2. Do not force the disc to work faster, reducing the Disc's
See Fig. A1
moving speed means longer working time.
3. Always work with a 15-30 angle between disc and
See Fig. A2
workpiece. Larger angles will cut ridges into the
workpiece and affect the surface finish. Move the
angle grinder across and back and forth over the
workpiece.
See Fig. A3
4. When using a cutting disc never change the cutting
angle otherwise you will stall the disc and angle
grinder motor or break the disc. When cutting, only cut
in the opposite direction to the disc rotation. If you cut
in the same direction as the disc rotation the disc may
See Fig. B
push itself out of the cut slot.
5. When cutting very hard material best results can be
See Fig.
achieved with a diamond disc.
C1, C2, C3
6. When using a diamond disc it will become very hot. If
this happens you will see a full ring of sparks around
the rotating disc. Stop cutting and allow to cool at no
load speed for 2-3 minutes.
7. Always ensure the workpiece is firmly held or clamped
to prevent movement.
See Fig. D
See Fig. E
See Fig. F
See Fig. G
EN