Assembly And Operation - Worx WX803 Manual Original

ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING! To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Help to minimize your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ACCESSORIES
WX803
Metal grinding
1
disc
Wheel guard
1
for grinding
Spanner 1
Auxiliary
1
handle
Battery pack
1
(WA3551.1)
Battery pack
1
(WA3553)
Charger
1
(WA3860)
Charger
/
(WA3880)
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
Lithium-Ion Cordless Angle Grinder
All manuals and user guides at all-guides.com
WX803.1 WX803.9
1 1
1 1
1 1
1 1
/ /
1 /
/ /
1 /
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended use:
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting metal, a special protection guard
for cutting (accessory) must be used.

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery pack
Installing the battery pack
WARNING: When replacing the
battery pack, do not insert the
battery until the Grinding/Cutting
Disc comes to a complete stop!
ASSEMBLY
Assembling Auxiliary Handle
Assembling Grinding/Cutting Disc
Adjusting Wheel Guard
Note: Before any work on the
machine itself, remove the battery
pack. For work with grinding or
cutting discs, the protection guard
must be mounted. Use the correct
type of disc for your application.
If the power tool is intended to
perform cutting off operations, a
guard specific for this operation
must be fitted.
The coded projection on the wheel
guard ensures that only a guard that
fits the machine type can be mounted.
Open the clamping lever. Place the
wheel guard with coded projection
into the coded groove on the spindle
of the machine head and rotate to the
required position (working position).
To fasten the wheel guard, close the
clamping lever.
The closed side of the wheel guard
must always point to the operator.
OPERATION
Using On/Off Switch
FIGURE
See Fig.
A1
See Fig.
A2
See Fig.
A3
11
See Fig. B
See Fig.
C1, C2,
C3
See Fig. D
See Fig. E
EN