Installing The Built-In Oven And The Built-In Hob - amzchef BD7504S03 Manual De Instrucciones

INSTALLING THE BUILT-IN OVEN AND THE BUILT-IN HOB

The kitchen should be dry and have effective ventilation according to the existing technical provisions.

Main lead behind the oven must be placed in such manner to avoid touching the back panel of the oven

because of the heat it develops during operation.
Remove any packaging materials( foils, artificial foam, nails ,etc.) from the reach of children, because they

represent potential danger. Children may swallow small parts, or suffocate with foils.
This is a built-in oven and built-in hob,which means that its back wall and one side wall can be placed next to a

high piece of furniture or a wall. Coating or veneer used on fitted furniture must be applied with a heat-resistant
adhesive . This prevents surface deformation or detachment of the coating.If you are unsure of your furniture's
heat resistance, you should leave approximately 2cm of free space around the oven. The wall behind the oven
should be resistant to high temperatures. During operation, its back side can warm up to around 50℃ above the
ambient temperature.
Make an opening with the dimensions given in the diagram for the oven to be fitted.

The appliance must be earthed.

Insert the oven completely into the opening without allowing the four screws in the places shown in the diagram

to fall out.
When installing the built-in oven and the built-in hob, the left side, right side, back and the bottom must be

surround by wall or cup board.
Connection
Electrical connection
All electrical work must be carried out by a suitably qualified and authorized electrician. No a terations or willful
changes in the electricity supply should be carried out.
Before attempting the connection, check whether the voltage indicated on the rating label corresponds to the actual
mains voltage.
Earthing wire should be installed in such manner to be the last one pulled out in case the safety relief device of the
mains lead should fail. Mains lead behind the oven must be placed in such manner to avoid touching the back panel
Warning
11