Ooni Karu 12 Manual página 5

WARNING
This manual includes an instruction to clean and inspect the
hose before each use of the appliance. If there is evidence of
abrasion, wear, cuts, or leaks, the hose must be replaced prior
to the appliance being put into operation. The replacement
hose assembly shall be that specified by the manufacturer.
WARNING
This appliance shall be used only outdoors, and shall not be
used in a building, garage, or any other enclosed area.
WARNING
This manual includes a list of required parts necessary for the
safe operation of the appliance, directions for proper assembly
and for assembly of installed parts and accessories supplied
with the appliance, and proper procedures for gas leak testing.
WARNING
The appliance should not be located or used under overhead
unprotected combustible construction materials or surfaces.
For a grill, fryer or broiler, the minimum clearance shall be at
least 10ft (3m) from any structure or combustible material.
WARNING
Make sure the legs on Ooni Karu 12 are fully extended before
use.
WARNING
To prevent shock, Do not to touch the electrode tip when
igniting the burner.
Gas regulator supplied may not be suitable for use in your territory or region, please refer to your local
regulations for more information.
Stand to side when relighting - never look directly into the oven or at the flame.
WARNING
Ensure the chimney vent are fully open during use.
WARNING
Do not adjust the chimney vent during use.
WARNING
Keep away from hot exhaust gases coming from the chimney.
WARNING
Please ensure there is a distance of at least 3.5" / 90mm
between the edges of any of the oven legs and the edge of the
table surface.
LP GAS CYLINDER WARNING
1. Do not store spare liquid propane gas cylinder under or near
this appliance.
2. Never fill the cylinder beyond 80 percent capacity.
3. Liquid propane cylinder must be fitted with an OVERFILL
PROTECTION DEVICE (OPD).
4. If the information above is not followed exactly, a fire
resulting in death or serious injury may occur.
5. This manual states that the installation must conform with
local codes or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA 54, Storage and
Handling of Liquefied Petroleum Gases, ANSI/NFPA 58; or
Natural Gas and Propane Installation Code, CSA B149.1;
Propane Storage and Handling, CSA B149.2
3