Echo 99944200225 Manual Del Usuario página 2

2
H
EAVY
Install 99944200225
1. Install the supplied upper adapter plate, with 25 mm arbor
(B), onto trimmer shaft.
2. Seat the trimmer head (C) onto 25 mm arbor of upper
plate.
3. Install large washer (D) to underside of trimmer head.
4. Lock the drive shaft using locking tool supplied with
trimmer.
5. Install and tighten nut (E) securely counter-clockwise
(CCW) and install a new split pin (F).
Installing Replacement lines
NOTICE
Do not allow more than four inches of line to extend from
cutter head. Long lines reduce engine speed and cutting
efficiency. Do not use cut-off knife on debris shield to trim
line, or damage to debris shield may result
st
Installing 1 line
• Insert one end between the lugs in position A leaving a 4
inch extension. Insert the other end of the line in position B
also leaving a 4 inch extension.
nd
Installing 2 line
• Feed one end under the loop in the center of the first line
and insert between the lugs in position C leaving a 4 inch
extension.
• Insert the remaining end between the lugs in position D
leaving a 4 inch extension. The lines should now be
interlocked in the center as illustrated.
• Adjust the length of all four lines to 4 inch, cutting off
surplus line as necessary.
Replacement Line (.130 inch diameter)
Echo Monofilament trimmer line is available from your Echo
Dealer.
- F L
DUTY IXED INE
T H
RIMMER EAD
D
99944200225
C
B
Nylon Line
A
B
C
Nylon Line
A
D
B
C
D E
F
B