Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DESCRIPTION G30044
1. Blade
5. Charging light
9. Small brush
OPERATING
The hair clipper can be recharged using the adaptor and it can be used both weather it is connected to the
adaptor or not.
WARNING: if during battery working the appliance stop working, put switch (4) in OFF position, connect
adaptor (11) to power supply and pin (12) to connector (6). Wait one minute before starting again operation.
HOW TO USE
- Keeping off the unit, mount one of the supplied combs (7). Choose the
attachment depending on the length you wish to obtain (3 – 6 – 9 – 12 mm).
Comb 4A:
3mm
Comb 4C:
9mm
To insert a comb, align the cutting blade and push until it snaps in position.
Also, use the lever (3) to decrease or increase the length of the cut (see figure).
You can use the clipper without comb only if you are using the hair comb (8) or if you want to make
precision finishes.
Once finished cutting operation, turn off the device by setting the power button (4) to "0" position.
-
-
Let it cool down then store the clipper and its accessories out of the reach of children.
RECHARGING -
If the adaptor gets lost or damaged, contact an authorized service center and do not use any other adaptor
which may damage the internal battery and jeopardize the functionality of the device. When you first use the
product fully charge it, leaving it connected to the charger for at least 10 hours.
Plug the power adaptor (11) to the power outlet and the connection pin (12) into the socket on the rear of
product (6). During charging operation, the LED (5) is red. When battery is fully charged, it becomes blue.
The following measures will preserve the battery life.
Before first use, charge the battery by leaving the hair clipper connected to the adapter for about 10 hours.
Before you recharged, completely discharged the battery.
When the unit is not in use for a long period (2 months), it is recommended to let it charge for about 10 hours
before using. In any case it is advisable to fully discharged the battery before recharging. If the appliance,
even after a recharge, works only if it is connected to the adapter, it is possible that the battery is no longer
capable of delivering enough power to the unit. In this case, please contact an authorized service center.
MAINTENANCE AND CLEANING
Disconnect the clipper from the power adaptor, and unplug it from the
power outlet before starting any cleaning operations.
After each cut, always clean used comb (7) and cutting blade (1) by blowing over them
or using the small brush (9). Periodically
lubricate the blade by following the steps below.
Open the flap placed beneath the cutting blade,
pushing the blade as shown in figure below.
Remove remaining hair by blowing or using the
small brush (9).
Use lubricating oil (10) for the blade. 2 or 3
drops are enough if this operation is carried out
frequently.
As shown in the figure, two points must be lubricated with oil:
Put 1-2 drops on the blade and 1-2 drops on the driveshaft joint. Use only the provided oil or similar oil
2. Comb
6. Charging input
10. Lubricating oil
Comb 4B:
Comb 4D:
CAUTION: to recharge the clipper, only use the adaptor supplied.
3. Cutting regulator
7. 2 combs set
11. Adaptor
6mm
12mm
4. On/off button
8. Shissors
12. Connection pin
11
Publicidad
Tabla de contenido
