Diagrama De Las Partes; Troubleshooting Your Mr. Coffee; Coffeemaker - Mr Coffee FT Serie Manual Del Usuario

DIAGRAMA DE LAS PARTES

1 0
9
8
7
26
1
1. Tapa de la Canasta del
Filtro
2. Cubierta de la Regadera
2
3. Tanque de Agua
4. Detenga y Sírvase
(Pause 'n Serve)
3
5. Ventanilla Doble
del Nivel de Agua
6. Plato Calefactor
7. Jarra
8. Canasta Removible del
Filtro
9. Tapa para Verter del
Tanque de Agua
4
10. Regadera
5
6

TROUBLESHOOTING YOUR MR. COFFEE

Your MR. COFFEE ® Coffeemaker has been carefully designed to give you many years of trouble-free
service. In the unlikely event that your new coffeemaker does not operate satisfactorily, please review
the following potential problems and try the steps recommended BEFORE you call an Authorized
Sunbeam Service Center.
PROBLEM POSSIBLE CAUSE
THE "BREW NOW"/ON • The appliance is unplugged.
LIGHT DOES NOT LIGHT UP • There's a power outage.
THE COFFEE IS • The appliance is unplugged.
NOT BREWING • There's a power outage.
• The water reservoir is empty.
• The filter basket is not
properly inserted.
• The decanter is not placed
all the way in on the
warmer plate.
THE COFFEEMAKER • There are no coffee grounds in
ONLY BREWS WATER the filter basket.
THE COFFEEMAKER BREWS • The coffeemaker needs cleaning.
SLOWLY
THE FILTER BASKET OVERFLOWS • The filter basket is not
properly inserted.
• The decanter is not placed
all the way in on the warmer plate.
• The decanter lid is not on decanter.
• Too many coffee grounds were
placed in the filter.
• The decanter was removed from
the warmer plate for more than
30 seconds.
PLATE OR IT
MIGHT CRACK.
THE COFFEE IS NOT HOT • There's a power outage.
• Auto SHUT-OFF has been activated.
®

COFFEEMAKER

SOLUTION
• PLUG UNIT IN.
• WAIT FOR POWER TO
BE RESTORED.
• PLUG UNIT IN.
• WAIT FOR POWER TO
BE RESTORED.
• CHECK THE WATER
WINDOWS.
• INSERT FILTER BASKET
CORRECTLY.
• PLACE DECANTER
CORRECTLY ON
WARMER PLATE.
• ADD THE DESIRED
AMOUNT OF COFFEE
TO THE PAPER FILTER.
• CLEAN COFFEEMAKER
SLOWLY AS
DESCRIBED IN
"CLEANING AND
MAINTAINING"
SECTION.
• INSERT FILTER BASKET
CORRECTLY.
• PLACE DECANTER
CORRECTLY ON
WARMER PLATE.
• PLACE LID ON THE
DECANTER.
• REMOVE FILTER,
DISCARD GROUNDS. IF
PAPER FILTER, REPLACE.
IF PERMANENT FILTER,
RINSE. BEGIN BREWING
PROCESS AGAIN.
• TURN OFF AND
UNPLUG THE UNIT.
ALLOW TO COOL. WIPE
UP THE SPILL. DO NOT
SET HOT DECANTER
BACK ON ON THE WET
WARMER
• WAIT FOR POWER TO
BE RESTORED.
• FOR BEST RESULTS,
BREW A FRESH POT OF
19