DeWalt D26453 Manual Del Usuario página 21

Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
For 115 V units with a power rating exceeding 1500
W, we recommend to fit a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm 2 .
When using a cable reel, always unwind the cable
completely.
Also refer to the table below.
D26453.PM7
Conductor size (mm
0.75
1.00
1.50
2.50
4.00
Voltage
115
230
Assembly and adjustment
.
Fitting sanding discs (fig. B)
The tool uses 5" (125 mm) hook and loop sanding
discs with an 8 hole dust extraction pattern.
• Place the tool on a table, sanding pad (4) up.
• Place the sanding disc directly on top of the
sanding pad.
• Hold the sanding pad (4) with one hand and align
the dust extraction holes (5).
• Press the disc firmly onto the sanding pad.
Setting the electronic speed control dial (fig. A)
The speed is infinitely variable from 7,000 - 12,000 min
using the electronic speed control dial (2).
• Turn the electronic speed control dial to the
required level. The correct setting, however, is a
matter of experience.
• Generally, harder materials require a higher
setting.
21
E N G L I S H
2
) Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5 15 25
Amperes Cable rating (Amperes)
0 - 2.0 6 6 6
2.1 - 3.4 6 6 6
3.5 - 5.0 6 6 10
5.1 - 7.0 10 10 15
7.1 - 12.0 15 15 20
12.1 - 20.0 20 20 25
0 - 2.0 6 6 6
2.1 - 3.4 6 6 6
3.5 - 5.0 6 6 6
5.1 - 7.0 10 10 10
7.1 - 12.0 15 15 15
12.1 - 20.0 20 20 20
Prior to assembly and adjustment always
unplug the tool.
12-09-2005, 12:35
30 45 60
6 6 10
6 15 15
15 20 20
20 20 25
25 25 -
- - -
6 6 6
6 6 6
6 10 15
10 15 15
15 20 20
20 25 -
-1
21