Sharp CD-BK260V Manual De Manejo página 9

! Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS
terminal and position the FM aerial wire in the di-
rection where the strongest signal can be re-
ceived.
Supplied AM loop aerial:
Connect the AM loop aerial wire to the AM
LOOP socket. Position the AM loop aerial for
optimum reception. Place the AM loop aerial on
a shelf, etc., or attach it to a stand or a wall with
screws (not supplied).
Note:
Placing the aerial on the unit or near the AC power lead may cause noise pickup.
Place the aerial away from the unit for better reception.
Installing the AM loop aerial:
< Assembling >
External FM aerial:
Use an external FM aerial if you require better reception. Consult your dealer.
75 ohm
coaxial
cable
Note:
When an external FM aerial is used, disconnect the supplied FM aerial wire.
! Speaker connection
Connect the black wire to the minus (-) terminal, and the red wire to the plus (+) ter-
minal.
< Attaching to the wall >
Caution:
" Use speakers with an impedance of 6 ohms or more, as lower impedance speakers
can damage the unit.
" Do not mistake the right and the left channels. The right
Wall Screws (not supplied) speaker is the one on the right side when you face the unit.
" Do not let the bare speaker wires touch each other.
" Do not allow any objects to fall into or to be placed in the
bass reflex ducts.
" Do not stand or sit on the speakers. You may be injured.
External
FM aerial
Right speaker
Red
Black
01/4/24 CD-BK260V(X)E1.fm
Left speaker
Incorrect
ENGLISH E-8