Barbecook KADUVA INOX Manual De Instrucciones página 31

Yellow flames
Impossible to light burner with igniter
Flames jumping out of the burner box
Excessive heat and flare-ups
Flames behind control panel
Regulator humming
Incomplete flame
Warming rack does not fit
TROUBLESHOOTING GUIDE FOR ELECTRIC IGNITION
Problem
No sparks when pressing the ignition;
no sound
No sparks when pressing the ignition;
sound is present
Sparks are present but not with all elec-
trodes and/or not powerful enough
HANDBUCH FÜR MONTAGE,
BETRIEB UND WARTUNG
• Venturi tubes are partly blocked
• Salt on burner
• The product is connected to Buthane.
• Ignition wire not fitted properly
• Defective ignition electrode
• Faulty ground
• Defective igniter
• Windy weather
• Cylinder almost empty
• Too fatty food
• Blocked fat drain hole
• Cooking system not positioned correclty
• Blocked venturi tubes
• Temporary situation caused by high outside temperature or
full cylinder
• Plugged, leaky or rusted burner
• Legs are angled too narrowly, or too widely
Probable cause
• Battery not installed correctly
• Empty battery
• Ignition button not installed correctly
• Defective spark generator
• Faulty ground
• Faulty ground
• Spark flashover away from burner(s)
• Low battery
• Electrodes are wet
• Electrodes cracked or brokenn "sparks are present"
-
-
• Clean venturi tubes
• Clean burner
• Connect the product to Propane with the right connector.
• Check all connections
• Check installation of electrodes, burner and igniter
• Replace igniter
• Move barbecue with rear side pointing towards the wind
• New cylinder or fill up
• Trim excess fat or reduce heat
• Clean bottom of burner box and burner
• Position cooking system correctly
• Shut off gas immediately, allow barbecue to cool down and
clean venturi tubes
• This is not a defect or a hazard
• Clean / replace burner
• The warming rack feet are adjustable. Bend them to fit into
the warming rack holes.
Solution
• Install battery (ensure that Ò+Ó and Ò-Ó are oriented cor-
rectly, with Ò+Ó at the top and Ò-Ó at the bottom)
• Replace with new AA battery
• Screw off button and reinstall
• Replace spark generator
• Remove and reconnect all connections with spark generator
and electrodes
• Remove and reconnect all connections to the spark genera-
tor and the electrodes
• If sparks are present that do not originate from the
burner(s), the wiring may be damaged. Replace the wiring.
• Replace with new AA battery
• Use paper tissues to remove the dirt
• Replace cracked or defective electrodes
-
-
-
-
-
-
-
www.barbecook.com
-
-
-
-
-
31