Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Generac Portable P roducts 1900 PSI P ressure Washer
How
to StopYour
Pressure
Washer
I.
Let engine idle for two minutes.
2.
Turn engine off according to instructionsgiven in
engine owner's manual.
3.
Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when you
releasethe pressure.
How to Use the Adjustable
Nozzle
You should now know how to START and STOP your
pressure washer.The informationin this section will tell
you how to adjust the spray pattern and to apply detergent
or other cleaning chemicals.
CAUTION
I.
NEVER adjust spray pattern when spraying.
NEVER put hands in front of nozzle to adjust spray pattern.
Slide nozzle forward when you wish to adjust spray to
low pressure mode (Figure 9). Slide nozzle backward
to achieve high pressure.
Slide nozzle backward
for High Pressure
Mode
Slide nozzle forward for low
pressure mode and
detergent application
2.
.
Point nozzle down towards a firm surface and press
trigger to test pattern (Figure I0).
Twisting nozzle adjusts spray pattern from a narrow
pattern to a fan pattern (Figure I I).
Rotate nozzle
counterclockwise
for fan
spray pattern
Rotate nozzle clockwise
for narrow spray pattern
4.
For most effective cleaning, keep spray nozzle from
8 to 24 inches away from cleaning surface.
5.
If you get spray nozzle too close, especially using high
pressure mode, you may damage surface being cleaned.
6.
DO NOT get closer than 6 inches when cleaning tires.
I
9
Publicidad
Tabla de contenido
