Philips SJM3151 Manual De Instrucciones página 11

4. Select the device and brand of the device
you want to add by using the cursor keys.
Press . The remote will search the
OK
database for available code sets.
5. Follow the on-screen instructions to test
the codes. When a working code set is
found, your device is correctly installed.
When the device is correctly installed, the
following screen appears:
If no working code set is found:
• You can perform a full data base search to
find a correct code set. This can take up to
25 minutes.
• You can learn codes from the original
remote device.
To add an additional device:
1. Select "Yes", Press
2. Repeat this process for each
additional device.
3. When you are finished adding devices,
select "No". Press
Getting Started
SJM315Final.indb 11
.
OK
. Exit the wizard.
OK
D
Note
You can adjust the settings of your universal
remote for iPod™ anytime after initial install
via the set-up menu. Press the
keys simultaneously for 3 seconds.
LAUNCH
The screen will ask you to press and hold the 2
keys for 3 seconds to enter set-up mode.
and
MODE IPOD™
11
8/14/07 4:10:28 PM