Set The Clock Manually; Time Zone Setting - Explore Scientific RDP1001 Manual De Instrucciones

NOTE: When using a power adapter, please increase the
separation of the main unit and the power adapter to
avoid interference of RCC signal receiving.

SET THE CLOCK MANUALLY

1. Press and hold [
date setting.
2. The setting parameter will flash.
3. Press [ ] button once, the figure will increase
1 unit (when setting minute, second will reset to 0).
Press and hold the [
increase rapidly.
4. Press [ ] button once, the figure will decrease
1 unit (when setting minute, second will reset to 0).
Press and hold the [
decrease rapidly.
5. Press [ ] button to confirm setting and enter
to next parameter.
6. Sequence of setting: Weekday Language 12/24 Hr
 Year (2000 – 2099)  Date format  Month 
Date  Hour  Minute  Zone  °C/°F  Exit
8
] button to enter time and
] button, the figures will
] button, the figures will
7. If there is no action in 20 seconds, the setting will be
saved and will exit the setting mode.
LANGUAGE
Sequence of setting weekday language:
German (GER)  English (ENG)  French (FRE) 
Italian (ITA)  Dutch (DUT).

TIME ZONE SETTING

To set a different time zone, proceed as follows:
1. Press and hold [
setting.
2. Press [ ] button several times until the display
shows the time offset "Zone 00"
3. Press the [
[ ] button to decrease the Time zone offset.
°C/°F SETTING
1. Press and hold [
setting.
2. Press [ ] button several times until the
display shows °C/°F.
] button, enter time and date
] button to increase or
] button, enter time and date