flow-med dry-star uv 2 Manual De Instrucciones página 4

EN INSTRUCTION MANUAL
Dries and cares your hearing systems
Moisture and ear wax can impair the function of hearing systems and cause failures. The dry-star uv 2 offers optimal care. Comfort drying at 50°C extends life
time significantly. Ultraviolet light (253,7nm UV-C) eliminates 99,9% of germs and bacteria. This clinical cleanliness prevents ear infections risks and protects
both your hearing systems as well as your health.
Using first time
1. Insert the USB-cable into the 5 V power supply and the round plug connector into the jack on the rear side of your drying station
2. Then plug the power supply into an AC power socket
Operation
3. Open the lid of your dry-star uv 2
4. Place the with wet wipes pre-cleaned hearing systems with the battery-door open (if possible) into your drying station
5. Briefly touch the sensor button and the comfort drying program (drying + UV-C) is starting automatically
• The 4 hours drying program with approx. 50°C warm air is fully processor controlled
6. Close the lid
• Ultraviolet light (253,7 nm) eliminates germs and bacteria to 99.9% within 4 minutes
• After 4 min the UV-C light switch off automatically, the drying process continues
• Within the last 4 minutes of the 4 hours drying program, a second UV-C hygiene runs
• After 4 hours the drying station automatically shutdown to stand-by
7. Open the lid again
8. Remove the dried and hygienically cleaned hearing systems
2
i The dry-star uv 2 is ready to use
i LED permanent light
i LED blink light
i LED permanent light
i LED blink light
i LED switch off